Speaker Cable Vs Instrument Cable. The smaller wires of the instrument cable are shielded in order to cope with its high impedance setting, acting to reduce disturbance from other electronics and nearby radio signals. This is because there is no shielding to preserve your instrument’s signal, and all that rf interference will “join” your instrument signal in its path to your amp.
INSTRUMENT CABLES vs SPEAKER CABLES What's the Difference? YouTube from www.youtube.com
If used between a power amp and speaker this cable will work fine at low levels but if the amplifier is capable of high power output the wires will quickly overheat and that can lead to damage if not addressed. Two plugs, 1/4 inch or 1/8 inch, with a few feet of cable in between. The smaller wires of the instrument cable are shielded in order to cope with its high impedance setting, acting to reduce disturbance from other electronics and nearby radio signals.
Two Plugs, 1/4 Inch Or 1/8 Inch, With A Few Feet Of Cable In Between.
The key difference between the two is shielding. Instrument cables are shielded and use much smaller wires and speaker cables are unshielded and use huge wire gauges. Speaker cables are meant to handle high current loads…from an amplifier to a speaker.
The Other Is A Ground Wire.
Several aspects set microphone cables apart from instrument cables. So speaker cables tend to be heavier and bigger than guitar cables. This is because there is no shielding to preserve your instrument’s signal, and all that rf interference will “join” your instrument signal in its path to your amp.
One Wire Carries The Signal.
Using the right cable at the right time can mean the difference between a crystal clear tone and a humming mess. Instrument and speaker cables may look the same, but they couldn't be more different. Amps, conversely, produce a lot of power.
The Smaller Wires Of The Instrument Cable Are Shielded In Order To Cope With Its High Impedance Setting, Acting To Reduce Disturbance From Other Electronics And Nearby Radio Signals.
Never use an instrument cable as a speaker cable. Typically without rf shielding (rf stands for radio frequency). Although i think you can use a speaker cable as an instrument without harming anything.
It Will Not Damage Your Equipment At All!
This is implemented because instruments produce a very weak signal path, and are therefore susceptible to unwanted signal interference, caused by electronic waves that move through the air. Your essentially sending a small signal into your powered speaker witch translates/amplifies that small hd500 signal. Mic level vs instrument level.
Location:
Share :
Post a Comment
for "Speaker Cable Vs Instrument Cable"
Post a Comment for "Speaker Cable Vs Instrument Cable"